BIM MODELING

MEP BIM Modeling (LOD 400 Revit)

We model the whole MEP package in Revit, floor by floor, from the cellar to the roof: plumbing, HVAC, fire protection and electrical.

What LOD 400 means for you

Real fittings, real hangers, real clearances and the equipment you are buying. Your foreman can build from it.

What we model

  • Plumbing: sanitary, vent, storm, domestic water, gas and medical gas
  • HVAC and mechanical piping: ductwork, chilled and heating water, steam, refrigerant, condensate
  • Fire protection: mains, branch lines, heads, standpipes
  • Electrical: power, lighting, conduit, cable tray

Read first, then model

At kickoff we go through the drawings and specs and send you what is missing, in writing, before a pipe is drawn.

What you get

Revit models (RVT), Navisworks files (NWC/NWD), DWG and PDF sheets.

Questions

What is LOD 400 in BIM?

A model detailed enough to fabricate and install from: real fittings, supports and equipment, not just pipe runs and boxes.

Can you model from contract drawings only?

Yes. We review the set at kickoff, list what is missing, and model from there.

Do you model one trade or the whole building?

Either. One model with all four MEP trades is where coordination pays off.

What software do you use for MEP BIM?

Revit for modeling, Navisworks for coordination, AutoCAD MEP and CAMduct for drawings and duct.

Send us your drawings. Upload a few sheets below, or email Team@pipedreamsolution.com.

Start a project

Send us your drawings.
We will show you the risks first.

Upload a few sheets or paste a link to the full set (Box, Dropbox, Google Drive, BuildingConnected, Procore). It goes straight to our team.

Rather email? Team@pipedreamsolution.com

Trades